10160
	Datsun V6 header installation
	Datsun PL620 72 1/2 - 79
	Package contents
	1 Right Header
	1 Left Header
	1 pr. Gaskets
	12  3/8"” head, header bolts
	1 Reducer kit with bolts & nuts
	2 large ACE decals
	Vehicle may need to be raised slightly.
	Clean head surface of all gasket material.
	Coat header gaskets. (Pam / High temp silicon recommended)
	Remove sparkplugs.
	Left side
	Pull fender well away from frame, trim as needed.
	Remove #2 cylinder tube from header.
	Guide header under and over steering column into place.
	Insert gasket, start header bolts.
	Install tube #2, start bolts.
	Tighten bolts from the center out.
	Install spark plugs and oil filter.
	Right side
	Pull fender well away from frame, trim as needed.
	Guide header down thru fender well into place.
	Insert gasket, start header bolts.
	Tighten header bolts from the center out.
	Install spark plugs. Check routing of secondary wires.
	After reaching operating temperature re-torque header bolts.
	Headers are coated with Rustoleum high heat barbeque paint.
	NOTE; Ceramic coated headers must be heat cycled,
	several times to prevent damage to the coating.
							3/23/2017